Rotomoulding company, rotomoulded part
19" RACK MOUNT CASES
CONTAINER 4U
Our new range of products rotomoulded fully meets all your specific constraints of transport, handling and environment. Our containers "rotoconcept" to combine both strength, lightness and maximum protection for your equipment.
(no deformation of the profiled closure, fitting lids is always possible).
This container is airtight lids closed: IP 649 according to standard NF EN 60 529 (sealed against dust and water splashes from all directions). The mechanical supports integration at 19 "are standard and conform to international standards.
Description of standard model
Number of openning : 2.
- Raw material: Polyethylene rotomoulded thickness 3mm
- Color : standard black.
- locking section : by rotomoulded.
- locking : by buterfly catches in steel.
- Handling: handles rotomoulded.
- labeling holder
- 19 inches rack mount : the frame is steel paint black
- Deph: 19 inches 510mm or 760mm
Characteristics
- Tightness level : Laying
- Used resist : Transport (air and sea freight)
- Materials : Plastic (Polyethylene - High Density)
OUR FORCE IS THE DEVELOPMENT OF SPECIFIC PRODUCTS
Rotoconcept design and manufaturing your project in plastic rotomoulded part :
rotomoulded case
QUALITY STEPS
We adjusted all our procedures the quality process of the frame of reference ISO 9001 V2000.
Ces procédures permettent de garantir à nos clients, un produit répondant parfaitement à ses exigences en terme de qualité mais aussi en terme de délais.
Rotomoulding company
Rotomoulded part - Rotomoulded case
Pièce composite
ZA des Bozées
BP 26107F - 53061 LAVAL cedex 9
Tél. : 33 (0)2 43 67 92 70
Fax : 33 (0)2 43 67 92 71
